3D Deco Light

3D Classic Car Light – Blue, with crack sticker, making it appear like the object has broken through with wall. Number plate can be personalised LED Lights Size: 17.5cm x 35cm x 7.5cm How to install your 3D Crack Sticker 1. Unfold sticker and flatten creases. 2. Place sticker at desired location, place tape (painter’s tape or similar) at the edge of the top of the sticker and mark arrows on tape and sticker for placement reference. 3. Carefully remove the back of the sticker. 4. Align arrows and carefully stick the top (top 1-2 inches) of the sticker to wall, make sure you hold the bottom portion away from wall. 5. Use a credit card or dull flat surface to slowly adhere the sticker, pressing against the paper backing, removing any air bubbles that may arise, remember to keep the bottom part of the sticker off the wall as you work your way down, out and towards the edges until the end. 6. Very slowly peel off the paper from the wall, making sure that the (fine edges) are stuck to wall. If any of the sticker peels up with the paper, simply put back against wall and press firmly with credit card until sticker adheres to wall. 7. Drill a hole in the spaces marked X and inset the wall plug, provided. Insert the screws provided to approximately ¾ of the way and place light onto screws. 8. Enjoy!

Link to buy

Subscribe now to our FREE newsletter!

Subscribe NOW to 7Gadgets newsletter! You will receive the weekly selection of the best gadgets!

It is FUN, it is COOL, it is 7Gadgets newsletter!

Subscribe now to our FREE newsletter!

One more step! Please check your inbox for an email with subject "7Gadgets: Please Confirm Subscription". You need to click the link in that email. This is a necessary step to ensure you entered the correct email address.

Pin It on Pinterest

Share This

Share this post with your friends!